Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Menu "HASE" (HA)
This menu is available only in systems with HA, and allows the user to configure the operation of the HA unit. The menu presents 1
parameter:
• "HASP" (Fig.24). Motor speed when
the
machine
is
recirculation mode.
24
24
P1
HA
P2
FILT
1
2
3
4
5
6
esc
set
Prg
/ °C
By-Pass
Setting "Mod Bus" parameters
The appliance is accessible from a network using Modbus protocol, connected via a serial port that must be configured
appropriately by the installer. With this connection, certain operating parameters of the appliance can be controlled or
displayed remotely.
Where the appliance is wired into a home automation system, it will be able to communicate with the rest of the network.
The cable needed for this connection is supplied with the product.
Modbus (HRI-E)
The modbus connection cable, which will be found in the packaging of the appliance, has the following colours:
Black --> -
White --> +
Grey --> G
The cable must be connected to the controller by way of the RS485 port.
The connector, coloured white, is coded and can be connected to the only port available on the PLC.
The maximum length of the direct Modbus-RS485 connection is 100 m, although if the appliance is wired into a RS485
network, the maximum length of the branch is 40 cm.
25
25
BLACK:
-
WHITE:
+
GREY:
G
12
operating
in
7
BLACK
WHITE
GRAY
Publicidad
