Axis A Manual De Instrucciones página 13

5
Screws
6
Washers
7
Screw gaskets
8
Gasket
Fastening the support unit, place the washer pipe support in the desired position. Insert the cables
inside the support so that they protrude by about 50cm. Insert the cable in the cable glands.
Keeping the base unit at about 20cm (7.9in) from the support unit, lock the cable glands. Set the
base unit up on the stand arranging the cables inside. Attach the base unit to the support unit by
using the provided screws, washers, screw gaskets and gasket.
1
Washer pipe
2 Nut
3
Ogive
Cut the cables to size and either restore or make the connections to the positioning unit. Shorten
the washer pipe as needed. Unscrew the nut and slide it along the pipe. Insert the end of the pipe
into the ogive. Lock the nut to the coupling.
Note
Make sure the washer pipe is securely tightened to prevent water leakage. In case of water
leakage, further tightening will be required.
AXIS Washer Kit A
13