Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Warning: The operation of any tool can
!
result in particles fl ying into your eyes,
which may cause severe damage. Before
operating a power tool, always wear safety
goggles or safety glasses with side shields
and a full face shield when needed. We
recommend Wide Vision Safety Mask for
use over eyeglasses or standard safety
glasses with side shields.
PRECAUTIONS ON USING YOUR CORD -
LESS TOOL
This product contains Nickel-Cadmium batteries which must be
disposed properly.
1.
Be aware that the tool is always in an operating
condition, because it does not have to be plugged into
an electric outlet.
2.
Fully charge the battery for better operation.
3.
Be sure the battery is snapped in place.
4.
When not in use, lock the switch
5.
When operating at a high place, be aware of things
below and around you.
6.
Before drilling into walls, ceilings, or fl oors, ensure that
there are no concealed power cables, gas or water
pipes inside.
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER
Save These Instructions
1.
Input: Only use the rated voltage marked at the charger
2.
Before charging, study the instruction sheet.
3.
Disconnect the power supply before making or breaking
connections to the battery.
4.
For indoor use only. Do not expose to rain.
Danger: High voltage present at charging
terminals. Do not probe with conductive
!
objects. Danger of electric shock or
electrocution.
SAFETY PRECAUTIONS WHEN USING
CHARGER AND BATTERY
1.
Do not charge battery when temperature is below
41˚F(5˚C) or above 122˚F(50˚C). The most suitable
temperature for charging is that of 20-25˚C.
2.
Never attempt to connect two chargers together.
3.
The charger is designed to operate on standard
household electric power. Do not attempt to use it on
any other voltage.
4.
Before you connect the charger to an AC power outlet,
make sure that the currency in your house equals the
required input at the charger.
5.
Do not insert foreign matter into the hole reserved for
the battery in the charger stand.
6.
Do not charge by means of an engine generator or DC
power source.
7.
Do not dissemble the battery and charger, incorrect
reassembly may result in a risk of electric shock,
electrocution or fi re.
8.
Do not store the tool and battery in locations where the
temperature may reach or exceed 122˚F(50˚C), such as
outside sheds or metal buildings in summer.
9.
Do not incinerate the battery, even if it is severely
damaged or completely worn out. The battery may
explode in fi re.10.
under conditions of extreme usage or temperature. If
liquid comes in contact with skin, wash quickly with
soap and water, then lemon juice or vinegar. If liquid
gets in your eyes, wash with a strong solution of boric
acid and seek medical attention immediately.
11.
Never short-circuit the rechargeable battery. Short-
circuiting the battery will cause a great electric current
and over heat. It results in burn or damage to the
battery.
12.
Charge battery pack only with the charger provided.
13.
The battery pack for this tool has been shipped in a low
charge condition, therefore, you should charge it prior to
use.
14.
Do not insert foreign objects into the ventilation slots
of the charger. Inserting metal objects or fl ammables
into the charger air ventilation slots will result in electric
shock or damage charger.
!
2
Battery leakage may occur
Danger: High voltage present at
charging terminals. Do not probe with
conductive objects. Danger of electric
shock or electrocution.
Publicidad
Tabla de contenido
