Nolangroup N-Com mcs III R Serie Manual Del Usuario página 10

EN
ONLY FOR HELMET N100-5 – positioning of wiring and microphone
Positioning the right side wiring and the microphone:
Lift up the plastic lining of the cheek padding (Fig. 6).

 Insert the microphone into the eyelet (Fig. 7) and position it in the special housing, then inserting the
metal boom in the groove found in the chin guard coupling frame (Fig. 8).
Caution: make sure that the side of the microphone support with the writing "N-Com" is facing inward.
 Fix the cable inside the helmet and make sure the right fixing clip snaps into its housing (Fig. 9).
 Reposition the plastic lining of the cheek padding, arranging it behind the two small stop hooks (Fig.
10).
Fig. 6
Fig. 9
10
Fig. 7
Fig. 10
Fig. 8