brentwood H-C1600 Manual Del Usuario página 6

To reset your heater when the Overheat Protection System has been activated, perform the
following:
1.
Turn the Power Control Switch to the 'O' position, and turn the Temperature Control
Switch to the lowest setting.
2.
Disconnect the power cord from the electrical outlet.
3.
Allow your heater to cool down for approximately ten minutes.
4.
Ensure that both the intake and the exhaust vents are clear of obstructions.
5.
Connect the power cord to the electrical outlet.
6.
Turn the Power Control Switch to the 'II' position, and turn the Temperature Control
Switch to the highest setting.
7.
If your heater does not operate normally, turn the Power Control Switch to the '0' position,
disconnect the power cord from the electrical outlet, and consult an authorized repair
technician.
TROUBLESHOOTING
If your heater fails to operate, perform the following:
1.
Review this manual to ensure that you understand the basic operations and features of
your heater.
2.
Check your household circuit breaker or fuse.
3.
Check for obstructions at the intake and exhaust vents.
•
If obstructions are present, refer to the instructions for resetting your heater when the
Overheat Protection System has been activated.
•
If no obstructions are present, and your heater still does not operate normally, turn the
Power Control Switch to the '0' position, disconnect the power cord from the electrical
outlet, and consult an authorized repair technician.
6