Barrette BOM-34116407 Instrucciones De Instalación página 6

4.
Attaching Bottom Rail Bracket Cover:
Test fit the rail panel. Once proper fit is ensured,
press bottom bracket covers onto the ends of
the bottom rail (Fig. 11) and set panel in place on
brackets.
5.
Connect Rails to Brackets:
a. Press top rail cap and bracket covers onto the
top rail that was cut in step 1 onto the top of the
panel. Press down on the top rail cap to ensure
that it fits snug onto the panel and that the top
rail bracket end covers are being held in place by
the line bracket (Fig. 12).
b. Using the holes in the bracket as a guide, pre-
drill two (2)
the rail up through the top rail. Drive two (2) 1
screws up through the hole locking the bracket,
panel and top rail together, being careful not to
drill through the top of the top rail (Fig. 13).
c. Install pyramid post top onto each post (Fig. 14).
NOTE:
STAIR RAIL INSTALLATION
1.
Assemble rail panels as described in "Rail
Installation."
NOTE:
• Taller posts (sold separately) may be
See "Post Installation" section for "Deck/Wood
Surface Installations."
6
⁄ " holes from under the bottom of
1
8
A rubber mallet may be needed for a proper fit.
needed for either bottom or top of the stairs,
depending on the angle of the stairway or
the location of where the posts will be
installed relative to the nose of the stair
tread. Bottom stair posts may also be
moved out from bottom step (Fig. 1).
Bottom Bracket Cover Bottom Bracket Cover
⁄ "
5
8
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Pyramid Top Pyramid Top
Post Post
Fig. 1