Polygroup SUMMER WAVES Manual Del Usuario página 2

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
ASSEMBLY:
1. Assemble the 3-Piece Pole
and the End Cap is at the opposite end.
2. Insert the Pole to the Vacuum Head making sure that it locks onto the v-shaped spring pin in the head.
3. Loosen the drawstrings on the open end of the Vacuum Bag
and make sure the drawstring is located completely below the lip of the Vacuum Body. Tighten the draw-string and tie a knot.
4. Connect a 5/8" garden hose to threaded hole on the Vacuum Head.
To Vacuum With A 5/8" Garden Hose (Not Included)
1.Assemble the aluminum pole.
3. Attach the vacuum bag to the vacuum head, tighten the
drawing string and tie a simple shoelace knot.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
2
OPERATION INSTRUCTIONS
by inserting the crimped ends into the round ends. Make sure that the section with the hole through the side is at the far end,
3
2
MST. Extended operating days and hours during peak season requirements.
and place it over the larger hole at the TOP of the Vacuum Head 1. Pull the bag over the lip
2. Attach the vacuum head to the open end of the 3-piece pole.
4. Hand tighten a 5/8" garden hose to the vacuum head.
OWNER'S MANUAL
5/8" hose