adm Touch LED PWM 60W-12V Guia De Inicio Rapido

ENGLISH
This device is designed for touch switching on and off
and dimming of LED lighting, in the form of LED tapes
and strips inside an aluminium profile.
Technical specifications
input voltage range
rated power
maximun load
IP protection class
Safety conditions
The manufacturer assumes no responsibility for any
damage caused by improper use of the product,
changes to its design, use of inappropriate items, or not
following these instructions.
-
The switch is designen for indoor use and has been
made for safe voltage of 12V/24V DC.
-
The total power of connected LED lighting fixtures
cannot exceed the rated power of the switch.
-
Installation must be carried out in accordance with the
installation instructions.
-
When installing the switch cannot be connected to a
power source. In case of any doubt, consult a
specialist.
-
To clean, use only a soft, dry cloth; do not use
detergents.
-
When not using the device for a long time disconnect
the cable from the power supply system.
12V DC 24V DC
60W 72W
< 5A < 3A
IP20
-
Installation should be carried out according to the scheme. Outputs from LED
and power lightning should be soldered to the switch , or in the version with
cables, connect eg with an electric block.
-
Check correctness of mounting and connections. Peel the protective foil
tapes. Install the switch at the selected place.
-
Turn on the power
Instruction manual
The switch function are performed by pressing with a finger of the switch button.
Pressing for about 1 sec performs the on/off function, or holding a finger for
longer performs the dimming function of the LED light source.
WARNING! If there is no reaction switch to touch, or continuous self-brightening,
disconnect the power supply, wait 30 seconds and reconnect the power supply.
Information on disposal of waste electrical equipment
Must not be discarded with household waste!
This product contains electrical or electronic components that should be
recycled.
Leave the product for recycling at the designated station, e.g.: the local
authority's recycling station.
Interruptor Touch LED PWM 60W-12V & 72W-24V
Installation
700262