BLACK&DECKER Price Pfister VB8 Manual De Instrucciones página 3

8
HOT
8D
8F
8A
8G
8 IRON PIPE SUPPLY CONNECTIONS
Valve Body Inlets (8B) and Outlets (8C) are designed to accommodate
Connect hot (8D) and cold (8E) water inlets to Valve Body (8A). Pipe Unions (8F) or
Couplings (8G) may be required (not included).
WARNING: For Iron Pipe Connections or threaded fittings, use thread sealant
or PTFE Plumber's tape according to manufacturer's instructions.
CAUTION: If using iron pipes, it is not recommended to reduce outlet pipe
diameter.
9
HOT
9C
9H
9G
9F
9 COPPER SUPPLY CONNECTIONS
Valve Body inlets (9A) and outlets (9B) are designed to accommodate a
Connect hot (9C) and cold (9D) water inlets to Valve Body (9E) and solder the joints.
WARNING: Remove Plaster Guard (9F), Backup Plate (9G) and Test Plug
(9H) prior to soldering any inlet or outlet connections. Failure to do so can result in
water damage.
For valves with integral stops, open valve stem prior to soldering (see step 15).
8B
8C
COLD
8B
8C
8E
1
/ -14 NPT pipe.
2
9B
9A
9D
9B
9E COLD
9A
1
" copper pipe.
/
2
ENGLISH
10
10D
48"
8" Min.
10 TUB & SHOWER OUTLET CONNECTIONS
Connect Shower (10A) and Tub (10B) Outlet Pipes to Valve Body (10C). Connect
Pipe Elbows (10D) (not included) to ends of both pipes. We recommend using drop
elbows (10D) (not included). Securely fasten to framing or other solid support. The
height for outlet pipes is measured from the center of pipe elbow to center of the valve
body, as shown.
WARNING: For Iron Pipe Connections or threaded fittings, use thread sealant
or PTFE Plumber's tape according to manufacturer's instructions.
WARNING: Use only 1 / 2 " Iron or Copper Pipe between valve
and tub spout (No PEX)! Do not reduce the inner pipe diameter!
11
11E
30" Min.
11 SHOWER ONLY OUTLET CONNECTIONS
Connect Shower Outlet Pipe (11A) to Valve Body (11B). Plug Bottom Outlet (11C) with
Pipe Cap or Plug (11D). Connect Pipe Elbow (11E) (not included) to end of the pipe. For
copper pipe outlets, we recommend using drop elbows (11E) (not included). Securely
fasten to framing or other solid support. The height for the outlet pipe is measured from
center of pipe elbow to center of valve body, as shown.
WARNING: For Iron Pipe Connections or threaded fittings, use thread sealant
or PTFE Plumber's tape according to manufacturer's instructions.
3
10A
10B
10D
11A
11B
11C
11D
10C