Publicidad
Enlaces rápidos
PARK HARBOR
Flush Mount
PHFL4122PC
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit
breaker is shut off. You don't need special tools to install this fixture. Be sure to follow the steps in the order given.
Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed
on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to
proceed, consult a qualified electircian.
CARE INSTRUCTIONS
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scoring
pads or powders, steel wool or abrasive paper.
SAVE THIS MANUAL: RETAIN FOR CONSUMER'S USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE
PRODUCT: FOR PRODUCT OR INSTALLATION QUESTIONS PLEASE CALL CUSTOMER SERVICE AT 1-800-221-3379.
INSTALLATION SHEET
™
PARKHARBORLIGHTING.COM
©2018 Ferguson Enterprises, Inc. 00000 02/2018
Publicidad
Manuales relacionados para Park Harbor PHFL4122PC
Resumen de contenidos para Park Harbor PHFL4122PC
- Página 1 INSTALLATION SHEET PARK HARBOR ™ Flush Mount PHFL4122PC FOR YOUR SAFETY WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don't need special tools to install this fixture. Be sure to follow the steps in the order given.
- Página 2 (FIG.1) INSTALLATION(Fig.1) 1. Thread the mounting screws(C) into the matching holes in the mounting bar (A). 2. Secure the mounting bar (A) to the outlet box with outlet box screws (B). 3. Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box.
- Página 3 (FIG.2) FIGURE 2 INSTALLATION; SECTION 2 1. Install the bulbs (not included), please do not exceed the maximum wattage capacity recommended on the socket (I). We recommend the use of a clear light bulb 2. put the glass (F) onto the fixture ring (G), then hold the fixture ring (G) with glass shade(F) up to the fixture Pan (D) and protrude the screws (E) through the holes on the fixture ring (G) and secure with ball nut (H).