Hinkley 15334 Instrucciones De Instalación

H H I I N N K K L L E E Y Y
DASH FAMILY

start here
Item No:
15334/15344
S
AFETY WARNING: TURN POWER SUPPLY OFF DURING INSTALLATION.
IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR
LOCAL AUTHORITY FORCODE REQUIREMENTS.
For use with 12V power systems
There are four different ways to install this fixture
brick assembly, wood assembly, drywall assembly, concrete assembly
Brick Assembly
1. Crate a space in the wall for mounting sleeve.
2. Place mounting sleeve in wall a secure with mortar.
3. Place fixture in mounting sleeve
4. Remove excess wire and use applicable tool to remove the outer jacket
of the cable to expose the Positive (black) and Negative (white) lead
wires
5. Make wiring connections between 12V power supply and fixture
Wood assembly
1. Crate a space in the wall for mounting sleeve and bracket
2. Secure back bracket to wall using wood screws
3. Secure mounting sleeve to back bracket using the provided hut nuts
4. Place fixture in mounting sleeve
5. Remove excess wire and use applicable tool to remove the outer jacket
of the cable to expose the Positive (black) and Negative (white) lead
wires
6. Make wiring connections between 12V power supply and fixture
Drywall assembly
1. Crate a space in the wall for mounting sleeve and bracket
2. Secure back bracket to wall using wall anchors
3. Secure mounting sleeve to back bracket using the provided hut nuts
4. Place fixture in mounting sleeve
5. Remove excess wire and use applicable tool to remove the outer
jacket of the cable to expose the Positive (black) and Negative (white)
lead wires
6. Make wiring connections between 12V power supply and fixture
Concrete Assembly
1. Crate a space in the wall for mounting sleeve.
2. Place mounting sleeve in wall a secure with mortar.
3. Place fixture in mounting sleeve
4. Remove excess wire and use applicable tool to remove the outer
jacket of the cable to expose the Positive (black) and Negative (white)
lead wires
5. Make wiring connections between 12V power supply and fixture
Note: Multiple fixtures can be wired to one transformer or power
source. Please refer to the specifications of the power source or
transformer for information on max load
Installation Instructions
Brick Assembly
No back bracket and
secured in mortar
Drywall Assembly
Use the back bracket and
standard wall anchors
HINKLEY 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkley.com
Wood Assembly
Use the back bracket and
wood screws
Concrete Assembly
No back bracket and
front holes used for framing