ENFORCER SM-226RQ Manual De Instrucciones

SM-226RQ / SM-226R-3Q
Overhead Door Magnetic
Contacts
Manual
Installation:
Please read manual before the installation.
1. Mount the contact on the floor near the
bottom of the door. Ensure that the
contact switch is in a safe location away
from equipment interference and near
where the magnet will be when the door is
closed.
2. Run the armored cable out of the way.
Run two wires from the alarm control
panel and connect to the two wires
extending from the cable armor.
3. Mount the magnet on the roll up door so
that it will trigger the contact when the
door is closed. Be sure that the gap
between the contact and magnet does not
exceed 2 / " (70mm).
3
4
NOTE: Contact and magnet must be installed
on the protected side of the door.
LIFETIME LIMITED WARRANTY:
SECO-LARM's obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be
responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse,
neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes
other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM's option.
In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited
warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also
not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com
SM-226RQ only
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product.
®
U.S.A., Inc.
Features:
 Operating voltage: 12~24 VDC
 2
/ " (70mm) Gap for overhead doors
3
4
 Adjustable to fit most door-channel widths
 24" (61cm) Armored wire leads
 Reed switch has deactivated rhodium on
gold under-plating
 SM 226RQ For closed-loop circuits
 SM-226R-3Q For open or closed-loop
circuits
Type: S
 Mounting bracket included
49J5
 Limited lifetime warranty
Parts List:
1x Contact Switches
1x Magnet with bracket
Floor on protected side of door
Website: www.seco-larm.com
1x Manual
Alarm
Control
Panel
®
PITSW1
MI_SM-226Rseries_191023_ML.docx