ROSIERES RVM 324 Instrucciones De Empleo E Instalación página 45

The hob does not operate or
certain zones don't work
HOB WITH SENSITIVE TOUCHES
The hob is not operating.
The hob does not cut off.
The hob stops automatically
Frequency of on/off operations
for cooking zones
"H" display,
indicator, blinking.
residual heat
• The shunts are not positioned correctly on the
terminal board. Have a check made that the con-
nection is done in compliance with the recommen-
dations, page 28 & 29.
• A big spill or object covers at least two buttons, for at
least 10 seconds. Clean up the spill or remove the
object.
• The control panel is locked. Press the "Locking" but-
ton to release.
• The control panel is locked. Press the "Locking" button
to release. Refer to the section, "Operating time" page
40.
• A spill covers at least two buttons for more than 10
seconds; the hob switches to safety, and an audible
beep sounds. Clean up the spill or remove the object.
• The cooking zones stop automatically if they are left
on for too long. Refer to the section, "Opera ting time"
page 40.
• The on-off cycles vary according to the required heat
level:
- low level: short operating time,
- high level: long operating time.
• The electronic temperature is too high. A technician
should verify the fitting in compliance with the
recommendations, page 30 & 31.
- 45