Panasonic TY-FB12LC Manual De Instrucciones página 3

Installation
Precautions
● Before removing, turn the main power of the unit off.
● When installing or removing the terminal board, exercise care to avoid injury.
There may be some sharp-pointed solder joints on the rear side of the board that could cause
unexpected injury.
● When installing the board, fully insert the Board into the slot horizontally until it is firmly plugged
into the connector.
Note that incomplete insertion may damage the internal components.
■
Compatible slot: SLOT1, SLOT2, SLOT3
■
Installation Procedure
1
Turn off the display and the connected equipment, and disconnect the power supply plugs from the
wall sockets.
Disconnect all cables connected to the unit.
2
Follow the procedure below and install the terminal board in the display.
To install
1. Remove the slot cover.
Securing screw
• Make sure that the Board does not ride on the two lower claws.
• Be sure to fasten all screws tightly.
• Have the customer keep the removed Terminal Board for future servicing needs.
2. Insert the terminal board until it is
firmly plugged into the connector.
Tighten screws in the order
2
4
3
Foam mat or thick soft cloth
3. Affix the terminal function
label (included).
1 4
- .
1
To remove
Remove the screws. Grip the handle of the
terminal board, and slowly pull out in the
direction of the arrow.
3