resideo AM-1 Serie Instrucciones De Instalación

AM-1 Series
TEMPERATURE GAUGE ADAPTER
° F
SPECIFICATIONS
Media Temperature Range: 70°F-180°F (21°C-49°C)
Lead Free Plumbing Code Compliance: The wettable sur-
faces contain less than .25% of lead by weighted average
Operating Pressure: 150 psi (1034 kPa) maximum.
Temperature Gauge Adapter: Lead-free brass, EPDM
o-ring, VR90 Gasket
Union Sweat Fitting
Gauge adaptor fits AM-1 series mixing valves.
Gauge dial is 2"and 2.5" diameter.
Installation of Temperature Gauge
Adapter
IMPORTANT
Union sweat connections must be soldered before
the thermowell with O-ring and sealing gasket are
installed. Install the thermowell with O-ring and
sealing gasket after the joint has cooled.
Resideo Inc., 1985 Douglas Drive North,
Golden Valley, MN 55422
www.resideo.com 38-00061EFS—02 M.S. Rev. 11-19 | Printed in United States
This product is manufactured by Resideo Technologies, Inc., Golden Valley, MN, 1-800-468-1502
©2019 Resideo Technologies, Inc. All rights reserved.
6 0
8 0
4 0 2 0 0
1 0 0
2 0
1 2 0 °C
0 ° C
M38267
INSTALLATION INSTRUCTIONS
1. Install thermowell with O-ring to the thermometer
adapter body.
2. Tighten to 75 LB-IN ± 10 LB-IN. DO NOT OVER-
TIGHTEN.
3. Install the thermometer into the thermowell until
seated and tighten the set screw to secure in place.
SCREW
Fig. 1. Temperature gauge installation.
Table 1. AM-1 Series Replacement Kits.
Part No.
AM1-TG100-US-LF/U 1/2" AM1 Temp Gauge Tail PC w/Sweat
AM1-TG101-US-LF/U 3/4" AM1 Temp Gauge Tail PC w/Sweat
AM1-TG102-US-LF/U 1" AM1 Temp Gauge Tail PC w/Sweat
TG200-UT/U Thermometer, 2" Dial w/ Threaded Well
TG250-UT/U Thermometer, 2.5" Dial w/ Threaded Well
THERMOMETER
THERMOWELL
O-RING
THERMOMETER
ADAPTER WITH
UNION NUT
GASKET
M36644
Description
38-00061EFS-02