Cleaning And Care; Troubleshooting - Klarstein 10031206 Manual Del Usuario

Important Hints
• When sticky food cooked,the pressure limit valve should not be raised before the indicator light of warm
keeping stops blinking and the float falls down. Otherwise,the food will go out from the release valve needle.
• In general, we suggest you wait for the pressure releasing by itself, but this process will take some time, If
you want to accelerate cooling,you can cut off the power,and cover the lid with a wet towel. if you want to
release the pressure by yourself, you`d better to release the steam when the indicator light of warm keeping
stays on, it indicates the pressure inside is going low. And you also should be careful because there is maybe
steam goes out.
• When the appliance is not in use and before cleaning, unplug the appliance from the outlet and allow it to
cool down before cleaning.
• Polish the cooker body with a soft cloth. Do not wash the body in the water or spray water over it.
• Take off the dew collector to wash thoroughly, then polish with a wet cloth, and put it back.
• Wash the inner of the lid thoroughly, including the seal ring, the pressure limit valve, the blocking proof, the
release valve needle, the float valve, and then polish dry with a soft cloth.
• Wash the inner pot with a sponge or a non-metal soft brush, and then polish dry the outside with a soft
cloth.
• The appliance must be dried completely before using.
Error Codes
Error Code
Problem

Troubleshooting

Problem
Difficult to close the lid
Difficult to open the lid

Cleaning and Care

Troubleshooting
E1
Sensor trip-out
Possible Cause
The seal ring is badly installed
The float sticks the pusher bar
The float is still up after releasing the
steam
E2
Sensor short circuit
Solution
Make good installation
Push the pusher bar gently
Press the float gently with chopsticks
E3
Signal switch out of work
18