The Right Grounding - voss.pet fenci M03 Instrucciones De Operación

The indicator LED (2) flashes in time with the electrical pulses.
3. Hold the non‑insulated part of a screwdriver against one of the connectors and
move the tip of the screwdriver towards the other connector.
A small and harmless flashover (spark) will be produced just before the tip touches the
connector.
If the indicator LED (2) does not flash, or you do not see a flashover spark, check the
mains voltage and power cable. If you find no faults, the energiser must be inspected by
a specialist.
NOTICE
Do not use multimeters to check the voltage. These are not suitable for the high
voltages generated by the electric fence energiser. Use specialist voltmeters,
such as type 44700 or 44876, to test the voltage.
7.3

THE RIGHT GROUNDING

WARNING AGAINST ELECTRICAL VOLTAGES
► Follow the safety instructions concerning location and installation when
grounding the fence (see section 2.2).
► Maintain a distance of 10 m to other grounded systems (e.g. protective
earthing of the power supply system or the earthing of a telecommunications
system).
► To prevent possible damage, ensure that animals or other people cannot
access the grounding. However, the grounding must be accessible for any
maintenance tasks required.
It is extremely important that the fence is properly grounded. With optimal grounding,
the VOSS.pet fenci can operate at its maximum capacity and ensure that your fence
provides the best possible security.
ऀ Where possible, select a damp area with vegetation for the grounding.
ऀ Use galvanised metal posts for the grounding posts. They must be at least 50 cm
long (e.g. item no. 44214).
ऀ If the soil is dry soil or if the fence is very long, install additional grounding posts at
intervals of about 2–3 m to improve the grounding. We recommend using the cable
with item no. 33615 to connect the grounding posts together.
32
INSTRUCTION MANUAL VOSS.PET FENCI
41205 | 12 | 2020 | V3