SMC Networks EZ-Stream Guia De Inicio Rapido página 7

3
Setup
CVBS Connection
Step 1: Connect the Left
(white) and Right (red)
Audio output jacks of the
SMCWMR-AG Universal
Wireless Multimedia Receiver
to any unused audio left and
right jacks on your stereo, TV,
or Audio/Video receiver.
Step 2: Connect the Video
(yellow) output jack on the
SMCWMR-AG Universal Wireless Multimedia Receiver
to any unused Video jack on your TV Audio/Video receiver.
Step 3: Connect the power cable from the back of the
SMCWMR-AG Universal Wireless Multimedia Receiver to the
nearest power outlet or, preferably, a fused power strip and
switch on your stereo or Audio/Video receiver. Do not forget to
set the receiver to the output mode that corresponds to the
jacks you used to connect to the SMCWMR-AG.
Configuration for Wireless Operation
Note: You will need your SMCWMR-AG Universal Wireless
Multimedia Receiver Remote Control if you wish to make
changes to the default settings.
Step 1: Turn on the SMCWMR-AG. By default, the SMCWMR-AG
Universal Wireless Multimedia Receiver will be configured to
connect to your SMC2804WBR Barricade g 2.4GHz 54 Mbps
Wireless Broadband Router and SMC2304WBR-AG EZ-Stream
Universal Wireless Broadband Router. The default settings are as
follows:
11
Step 2: If your network is not
configured as specified in Step 1,
you will need to configure the
SMCWMR-AG to properly establish
a connection to your wireless
Step 2 network.
Step 3: The SMCWMR-AG
will automatically ask you to
reconfigure your settings if
it was not able to get connected
with the default settings.
Step 4: Please answer the on-
screen questions to complete
the setup.
• SSID: [SMC]
• WEP: [Disabled]
• Internet Proxy: [Disabled]
• IP Address: [DHCP Enabled (Obtain IP Automatically)]
• Mode: [Infrastructure]
a) [Network Interface]: Select
[Use Wireless (802.11)] to
use a wireless network.
Remember, to make a
selection, press the [OK]
button on your Remote
Control.
b) You will then be asked to
input the SSID of your wireless network. Use the Up/Down
arrows on your Remote Control to choose the appropriate
letters. Use the Left/Right arrows to skip to the next letter of
the SSID. Press [OK] on your remote control when finished.
Step 4(c)
Step 4(e)
Step 4(f)
12