Hunter The Millenniom Guia Del Propietario página 4

maintenance
This fan is permanently lubricated
and will not require additional lubri-
cation (oil) for the life of the fan.
This fan requires little maintenance
and contains no user serviceable
parts. DO NOT try to fix it yourself.
Contact qualified service personnel
if servicing is needed.
TO CLEAN:
1. Before cleaning, turn fan off
and unplug from electrical out-
let. Wipe off excess dust with a
lintfree cloth.
2. To ensure adequate air circula-
tion to the motor, keep vents
Grill
Ring
Decorative Piece
(Only on 9103x & 9703x
models)
FIGurE 4
44801-01
located at the rear of the motor
housing free from dust accumu-
lation. A vacuum cleaner hose
can be used to clean these
vents.
3. DO NOT immerse the fan in
water or any other liquid.
CLEANING GRILL AND BLADE:
1. Turn the fan off and unplug
from the electrical outlet.
2. Disassemble grills by carefully
removing the screw on the bot-
tom of the ring. See Figure 4.
3. Remove the ring, lower deco-
rative peice (only on 9103x &
Decorative Piece
(Only on 9103x & 9703x models)
Screw
[6]
02/07/2008
9703x models), and front grill.
See Figure 5.
4. Grills and blades may be
cleaned with mild soap and wa-
ter.
5. Use a soft, slightly damp cloth
to wipe the remaining fan
parts.
6. DO NOT allow water or any
other liquid to get into the mo-
tor housing or base.
Decorative Piece
(Only on 9103x & 9703x
models)
Front
Grill
Decorative Piece
(Only on 9103x & 9703x
models)
FIGurE 5
44801-01
7. Reassemble the fan after
blades and grills have dried
completely. Align the grills, re-
place the ring, replace the dec-
orative piece (only on 9103x &
9703x models) and replace the
screw.
NOTE: To replace the decora-
tive piece, partially install the
screw, then hold the decorative
piece between the open ends
of the ring. Finish tightening
the screw.
8. DO NOT plug fan into an elec-
trical outlet until it has been
fully reassembled.
Ring
Back Grill
[7]
02/07/2008