SHELF-MADE 243-WT Instrucciones De Instalación

Installation Instructions
Ledge Shelving
243-WT | 243-BK
Tools Required (not included):
- Power Drill
- 3/32" Drill Bit or 3/16" Drill Bit
- Screwdriver
- Tape Measure
- Level
Installation Materials (included):
- (3) Ledge Shelves
- Mounting Hardware
Load Rating:
- 40 lbs each shelf when mounted
onto studs
2700 Oak Industrial Dr. NE
Grand Rapids, MI 49505
800-253-1561
www.kv.com
customer.service@kv.com
Installation
:
STEP 1: Select installation areas and mark the keyhole locations on wall the correct
distance apart. Use a level to make sure the ledges will be straight, as shown in Figure 1.
STEP 2: Pre-drill pilot holes with a 3/32" drill bit in the marked locations. If a stud is
present, insert and fasten the screw leaving a 5/32" gap. If no stud is present, use a 3/16"
drill bit to enlarge the 3/32" hole. Insert the anchor and fasten the screw into the anchor
leaving a 5/32" gap, as shown in Figure 2.
STEP 3: Attach each ledge by placing the keyholes over the screws and applying a light
downward force, as shown in Figure 3.
NOTE: Shelving can be installed with the sides pointing up or down.
x
Level
Back of Shelf
Figure 1
5/32"
Stud
Figure 2
Figure 3
©2015 Knape & Vogt. KV and the KV logo are trademarks of Knape & Vogt.
x
5/32"
310460/0715