Febo Flame F16-I-006-089 Manual Del Usuario página 5

INSERT OPERATING INSTRUCTIONS
5. Flame: Press to activate the flame function. This
button controls the brightness of flame and ember
effect. When the fireplace is first turned on, the
flame will come in at the highest setting; press
DOWN or UP button to adjust the brightness of
flame. There are 6 levels you can cycle through,
including the OFF setting (the ember remains on.)
When adjusting the flame brightness with UP and
DOWN button, the number of the flam level bars
corresponds to the 5 brightness levels. When this
feature is on, display screen FLAME icon is on
also.
6. HEATER: Press to activate the heater function.
The system will start the temperature setting at
95 ºF . There are 7 adjustable heat levels, ranging
from 65 ºF to 95 ºF . Press the DOWM or UP button
to adjust the levels, noting each level increases or
decreases the temperature by 5 ºF . When this
feature is on, display screen HEATER icon also.
And when this feature is off, the inner blower will
continue to run for additional 30 seconds to cool
down the unit order to protect the heating elements
before the unit completely shuts off.
Note: You can switch the temperature display
from Fahrenheit to Celsius by pressing and
holding the HEATER button control panel for
approximately 6 seconds, the display screen
will show the room temperature.
5
6
PAGE 5 OF 34
Figure 5
Figure 6