SPX JOHNSON PUMP PUMProtector Manual De Instrucciones página 9

• Connect two separate ports to PUMProtector housing, by the
KlickTite quick connectors.
Straight connectors, ½" barb combined with / " pipe thread and ¾"
3
8
barb combined with ½" pipe thread are included in PUMProtector kit.
For use of port threads, cut the barb part of the connection unit.
Other KlickTite port connectors are available as extra accessories.
See page 29.
When using solid pipework, always use an unclamped flexible hose
between solid pipework and pump/strainer unit. Recommended hose
length is 300 mm at both inlet and outlet side. This is to avoid noise
transfer from pump to hull and also to achieve a more gentle opera-
tion of pump.
If the pump fails to prime, check that all joints are properly sealed.
Maintenance.
Inspect the strainer unit regularly for clogging. A clogged strainer unit
reduces performance and service of pump and pump system. For
cleaning, release the strainer unit by the two KlickTite quick connec-
tions and bring it to a place where it is easy to clean. For Universal
Strainer you also need to loosen the two screws for attachment, ap-
prox. 1 – 2 turns. Twist the cover off and take the strainer screen out.
Clean the screen, strainer housing and cover. A dish wash detergent
may be used.
9
Original instructions