D-Link DES-1210-28P Guía De Introducción página 3

Management Options
The D-Link Web Smart Switch can be managed in-band
by using Telnet. The user may also choose the Web-
based Management, accessible through a web browser
or through any PC using the SmartConsole Utility.
If you want to manage only one D-Link Web Smart
Switch, the Web-Based Management is the better option.
Each switch must be assigned its own IP Address, which
is used for communication with Web-Based Management
or an SNMP network manager and the PC should have
an IP address in the same range as the switch.
However, if you want to manage multiple D-Link Web
Smart Switches, the SmartConsole Utility is the better
option. Using the SmartConsole Utility, you don't need to
change the IP address of your PC and it is easy to start
the initial setting of multiple Smart Switches.
Please refer to the following detailed installation
instructions for the Web-Based Management,
SmartConsole Utility, Telnet Management and SNMP-
Based Management.
Web-based Management Interface
After a successful physical installation, you can configure
the switch, monitor the LED panel, and display statistics
graphically using a web browser, such as Netscape
Navigator (version 6.2 and higher) or Microsoft
Explorer (version 5.0 and higher).
You need the following equipment to begin the web
configuration of your device:
 A PC with a RJ-45 Ethernet connection
 A standard Ethernet cable
Step 1
Connect the Ethernet cable to any of the ports on the
front panel of the switch and to the Ethernet port on the
PC.
Figure 6. Connected Ethernet cable
Step 2
In order to login and configure the switch via an Ethernet
connection, the PC must have an IP address in the same
range as the switch. For example, if the switch has an IP
address of 10.90.90.90, the PC should have an IP
address of 10.x.y.z (where x/y is a number between 0 ~
254 and z is a number between 1 ~254), and a subnet
mask of 255.0.0.0.
Open your web browser and enter http://10.90.90.90
(the factory-default IP address) in the address box. Then
press <Enter>.
Figure 7. Enter the IP address 10.90.90.90 in the web
The web configuration can also be accessed through the
SmartConsole Utility. Open the SmartConsole Utility
and double-click the switch as it appears in the Device
List. This will automatically load the web configuration in
your web browser.
®
Internet
Step 3
When the following logon box appears, enter "admin" for
the password. Press OK to enter the main configuration
window.
Step 4
Before entering the Web-based Management, the
Smart Wizard will guide you to quickly configure some
functions, such as Password Settings, SNMP Settings,
and System Settings. If you don't plan to change
3
browser
NOTE: The switch's factory
default IP address is 10.90.90.90
with a subnet mask of 255.0.0.0
and a default gateway of 0.0.0.0
Figure 8. User authentication window