Final Steps; Troubleshooting - Remus 76105979000 Instrucciones De Instalación

FINAL STEPS

IMPORTANT: reinstall the dismounted or partially removed stock parts
wheel arches, bumper etc.); check vehicle manufacturer manual for
tightening torques.
IMPORTANT: make sure all the nuts and bolts are sufficiently tightened.
In case the exhaust system touches the cowling or other parts, repeat the
adjustment of the exhaust system or contact your authorized dealer.
IMPORTANT: clean all exhaust components before the first start of the
engine or the stains will burn onto the surfaces!

TROUBLESHOOTING

Problem
Exhaust gas is leaking out
of the exhaust system
Valve is not working / moving
Exhaust system rattles /
doesn't fit properly
Errors and omissions excepted!
Possible cause
loosened clamp
connection is not
completely joined
Valve is mechanical stuck
Valve is not working correct
Exhaust System is not mounted
correct
15
Solution
tighten all connections to specified
torque
loosen the connection and tap it into
place, tighten the connection to
specified torque
Remove the actuator and try to move
the valve by hand. Use spray lubricant
(WD-40® or equivalent) to make the
valve working again.
Make sure the actuator is powered
correctly. Make sure the actuator is
mounted properly onto the valve and
the valve spins correctly.
loosen all connections again and
readjust/ align the whole system
once more