Dab Radio - auna multimedia 10027920 Manual De Instrucciones

FM Settings menu
There are some menu settings specifically fit for FM radio operation. These may be changed through the
settings menu. Set to FM mode. Press and hold the MENU button for 2 seconds ( front panel). You will
gain access to the settings: Scan setting – Audio setting – Set time/date – Factory reset – Sw version
SCAN SETTING:
to two different levels- "Strong stations only" or "All stations. "Setting to "Strong stations only" will
exclude weaker stations resulting in a quicker scan. If you set to "All stations" the scan will stop at every
station detect, even if the signal is weak.
AUDIO SETTINGS:
Stereo) or in Mono only. This may be useful if the signal is weak and the broadcast is noisy.
SET TIME/DATE:
DAB transmission.
FACTORY RESET:
and any stored preset stations will be cleared. After factory reset the radio will automatically re-scan
the DAB.
SW VERSION:
installed in your radio. This might be helpful to a technician who is servicing the radio.
Initial scan
When your radio is switched on for the first time the scanning display will be shown while the scanning
process takes place: The radio scans all usable stations (full scan) and stores them in alphanumerical
order. The initial scan will take a few minutes. After the scan, the clock will be set and the radio will play
the first station in the sequence. To browse for another station, refer to the next section
Re-scanning for DAB stations
When used first, your radio scanned the DAB band for available stations. The station services found
were then stored in your system's memory. You can re-scan the band at any time if you move to a
different area or just to refresh the stored list of available stations. To scan for DAB stations manually:
• Select the DAB band.
• Press the PAIR/ SCAN button on the front panel. The scanning process will take a few minutes. The
number of services found during the scan will be shown at the right side of the display.
• After the scan, the radio will re-tune to the station in the station list to play if it is available.
Browsing for a station
Turn the TUNE knob. <Station list> will be displayed. Turn the TUNE knob to browse the station list.
Press the SELECT knob to select the station displayed. After short delay, the radio will tune to the station
With this menu option you can set the Scanning sensitivity of the FM radio
This option enables you to set the radio to receive FM in Auto mode (Mono/
This main option enables the clock to be set manually if there is no available
This option will restore all settings to "factory original". All clock, station lists
This option will display the version number of the control software currently

DAB Radio

17