Canopy Assembly; Rod Support Assembly - Litex E-KM52ABZ5LKRCI Guia De Instalacion

7. Canopy Assembly.

Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert
screws (along with star washers) that were
previously removed (page 3, Section 4) and
secure all screws with Phillips screwdriver.

8. Rod Support Assembly.

Hook one end of rod to loop on motor housing.
Adjust rod support to top end of rod so it holds
the rod in place and tighten rod support set
screw. Allow rod support cap to rest on rod
support.
Install remaining rods in between motor
housing and rod support. If rods fall off easily,
re-adjust rod support (by re-adjusting rod
support set screw as described above) with
rods already installed.
rod support
set screw
rod
loop
page 6
hanging bracket
slotted
hole
canopy
canopy
rod support cap
rod support
yoke cover
motor housing