Safety Information - AD Instruments AD511 Manual De Usuario

Introduction
Uni-Trend Model UT511 insulation resistance tester (hereafter, "the Meter") is a handheld instrument designed primarily to make resistance/ insulation resistance
measurement.
Unpacking the Meter
The Meter includes the following items:
In the event you find any missing or damage, please contact your dealer immediately.

Safety Information

This Meter complies with the standards IEC61010 safety measurement requirement: in pollution degree 2, overvoltage category (CAT. III 600V, CAT.III 1000V) and
double insulation.
CAT II: Local level, appliance, PORTABLE EQUIPMENT etc., with smaller transient voltage overvoltages than CAT. III
CAT III: Distribution level, fixed installation, with smaller transient overvoltages than CAT. IV
Use the Meter only as specified in this operating manual, otherwise the protection provided by the Meter may be impaired.
Danger identifies conditions and actions that pose hazard(s) to the user.
Warning identifies avoiding electric shock.
Caution identifies conditions and actions that may damage the Meter and carrying out accurate measurement.
International electrical symbols used on the Meter and in this Operating Manual are explained on
Use of instrument in a manual not specifed by the manufactuer may impair safety features/protection provided by the equipment. Read the following
safety information carefully before using or servicing the instrument.
Do not apply more than 1000VDC or 750V AC.
z
Do not use the Meter around explosive gas, vapor or dust.
z
Do not use the Meter in a wet environment.
z
When using the test leads, keep your figures away from the lead contacts. Keep your figures behind the finger guards on the leads.
z
Do not use the Meter with any parts or cover removed.
z
When carrying out insulation measurement, do not contact the circuit under test.
z
Do not use the Meter if it is damaged or metal part is exposed. Look for cracks or missing plastic.
z
Be careful when working above 30V rms, 42V ac rms and 60V DC. Such voltages pose a shock hazard.
z
Discharge all loading of circuit under test after measuring high voltage.
z
Do not change battery when the Meter is in wet environment.
z
z Place test leads in proper input terminals. Make sure all the test leads are firmly connected to the Meter's input terminals.
Make sure the Meter is turned off when opening the battery compartment.
z
When performing resistance tests, remove all power from the circuit to be measured and discharge all the power.
z
When servicing the Meter, use only the same model number or identical electrical specifications of test leads and power adaptor.
z
Do not use the Meter if the battery indicator (
z
long time.
Do not use or store the Meter in an environment of high temperature, humidity, explosive, inflammable and strong magnetic field.
z
performance of the Meter may deteriorate after dampened.
Soft cloth and mild detergent should be used to clean the surface of the Meter when servicing. No abrasive and solvent should be used to
z
prevent the surface of the Meter from corrosion, damage and accident.
Dry the Meter before storing if it is wet.
z
©Copyright Abacanto Digital SA.
_______________________________________________________________________________
Item
1 English Operating Manual
2 One plug test lead to one alligator
3 Two plugs test lead to one alligator
5 1.5V Battery (LR14)
6 Tool Box
7 Power adaptor (optionally, available at extra cost)
) shows a battery empty condition. Take the battery out from the Meter if it is not used for a
Manual de usuario AD511
Table 1. Unpacking Inspection
Description
page XX.
Danger
Warning
Caution
AD Instruments
Qty
1 piece
1 pair
1 piece
8 pieces
1 piece
1 piece
17
The