Setting The Clock Time On The Docking Speaker; Sleep Timer; Led Display Brightness; Play - Honeywell Ovale OVD270 Manual De Instrucciones

SET UP (CONTINUED)

Setting the Clock Time on the Docking Speaker

SECTION
1. Make sure the Docking Speaker is in Standby Mode, or
switch to Standby Mode by pressing and holding the
Button for 2 seconds until the Display Screen shows the
clock time.
2. Press and hold the
about 2 seconds, until you see "24H" or "12H" blinking
on the LED Display Screen.
3. Press the Button to select a 12 or 24 Hour display
format. Press the Button to confirm.
4. Press the Button repeatedly to select the hour time
setting. The Hour digits will blink while you select the
correct Hour digit. Press the
5. When the Hour digit has been set, press the
again to select the Minute setting. The Minute digits will
blink while you select the correct Minute digit. Press the
Button to confirm.

Sleep Timer

1. The Docking Speaker can switch to Standby Mode
automatically after a set period of time.
2. Press the SLEEP Button repeatedly on the Remote Control
to select a period of time before the Docking Speaker
switches to Standby Mode. Choose from 90, 60, 30,15 or
00 minutes. After choosing the Sleep Mode time period,
the Docking Speaker will automatically switch to Standby
Mode after that set period of time has elapsed.
IMPORTANT: After the Docking Speaker switches to
Standby Mode, the Sleep Timer is deactivated. It must be
reset each time you want to activate a Sleep Timer.
IMPORTANT: If you wish to deactivate a set Sleep Timer,
press the SLEEP Button on the Remote Control again to
select S- 00 which means no time period has been set for
the Sleep Timer.

LED Display Brightness

There are 4 different brightness levels to choose from. To
set the brightness level using the Docking Speaker:
1. Make sure the Docking Speaker is switched to Standby
Mode.
2. Press the or Button to select the desired brightness
level.
To set the brightness level using the Remote Control,
press the DIM Button repeatedly until you reach the
desired brightness.
6
All manuals and user guides at all-guides.com
Button on the Docking Speaker for
Button to confirm.
Button

PLAY

Press the Button to select one of four Audio Source
Modes:
• "iPod" - iPod/ iPhone/ iPad Dock
• "bt" - Wireless Bluetooth
• "87.5" - FM Radio
• "AUX" - Aux In

iPod/ iPhone/ iPad DOCK AUDIO SOURCE

Play from an iPod/ iPhone/ iPad.
Lightning
Dock
Connector
1.
Lift the Lightning Dock Cover and gently place the iPod/
iPhone/ iPad onto the Lightning Dock Connector. Insert
the iPad Stand behind the Lightning Dock Connector
when docking an iPad.
IMPORTANT: You must remove any external iPod/
iPhone/ iPad case before docking the device onto the
Docking Speaker.
2. Press the Button repeatedly until you see "iPod"
displayed on the LED Display Screen.
3. The connected iPod/ iPhone/ iPad plays automatically, or
press the Button on your device, or on the Remote
Control to play music.
4. To pause/ resume play, press
5. To skip a track, press
Charging an iPod/ iPhone/ iPad
When the speaker is connected to power, the docked
iPod/ iPhone/ iPad begins to charge and continues to
charge until the iPod/ iPhone/ iPad is disconnected from
the speaker.
Repeating the Current Song
You can choose to repeat the current song being played
in the iPod/ iPhone/ iPad Dock Audio Source Mode by
pressing the REPEAT Button on the Remote Control.
"REP" will display on the LED Display Screen for 2
seconds when the REPEAT function is first activated.
Press again to deactivate the REPEAT function so that the
next song can be played.
Lightning
Dock
Cover
iPad Stand
Insert here
(Only when
docking an iPad)
.
/ .