Parts; Before First Use; Features; Using The Control Panel - Ninja JC100EU Instrucciones

PARTS

A Cleaning Brush
B
Tamper
C
Food Tray
D
Feed Chute Chamber
with Anti-Drip Lever
E
Auger
F
Black Filter (low pulp)
G Grey Filter (medium pulp)
H Orange Filter (high pulp)
I
Inner Pulp Spout
J
Outer Pulp Spout
K
500ml Juice Jug
L 710ml Pulp Container
M Motor Base (power cord not shown)
A
E
B
F
G
C
H
D
30 ninjakitchen.eu
I
J
K
L
M
ORDERING REPLACEMENT PARTS
To order additional parts and attachments,
visit ninjakitchen.eu

BEFORE FIRST USE

1 Remove all packaging materials from the unit.
IMPORTANT: Review all
NOTE: The feed chute chamber (D), auger (E), orange
warnings on pages 28-29
filter (H) and 2-part spout (I,J) are pre-assembled.
before proceeding.
2 Disassemble and clean all parts before first use. Wash parts in
warm, soapy, water, then thoroughly rinse and air-dry all parts.
NOTE: All attachments
3 Wipe control panel with a soft cloth. Allow it to dry completely
are BPA free and
before using.
dishwasher safe.
4 Assemble as per instructions on page 32.

FEATURES

USING THE CONTROL PANEL

START/STOP
Press once to start continuous running up to 12 minutes; press again to stop.
REVERSE
If the feed chute chamber becomes blocked or ingredients are not
processing, press and hold REVERSE. There will be a beep and a brief
pause, then the auger will rotate in the opposite direction. Release
REVERSE to stop. Repeat as needed. Press START/STOP to resume
normal operation.

USING THE FILTERS FOR PULP CONTROL

Control the amount of pulp by choosing the desired filter.
LOW PULP
Use the black
filter with the
finest mesh
for juice with
minimal pulp.
NOTE: For best results, we recommend using the Grey (Medium Pulp) or Orange (High
Pulp) filter when processing soft fibrous fruits like berries, seeded melons and pineapple.
MEDIUM HIGH PULP
PULP
Use the
Use the grey orange filter
filter with the with the
larger mesh largest mesh
for juice with for juice
some pulp. with lots of
pulp.
ninjakitchen.eu 31