Matco Tools MTDPGHV8 Manual De Instrucciones página 2

Matco Tools Instruction Manual for MTDPGHV8, MTDPGHV1
This instruction manual contains valuable information for your work and safety.
Please read the manual carefully before operation and retain it for future reference.
CAUTION
• All operations including maintenance should be carried out ONLY by knowledgeable operators.
• Never aim the Matco Spray Gun towards humans or animals.
• Be aware of the conditions of your surroundings, and keep the spray equipment and the object
being sprayed firmly on the ground at all times.
• Do not exceed the maximum working pressure of the equipment
• Fluid and solvents can be highly flammable and corrosive. Handle with extreme care, and
keep away from fire and electrical hazards.
• Toxic vapors produced by spraying can cause serious damage to health. Always wear
protective equipment and use the Matco Spray Gun in well ventilated areas.
• Halogenated hydrocarbon solvents may cause chemical explosions. Use paint materials
which are chemically compatible with aluminum, copper and zinc parts.
• Always release air and fluid pressure before cleaning/disassembling/servicing. A ball-valve
installation is recommended for emergency stop and prevention of unintentional operation accidents.
• Make sure all parts, screws, and nuts are intact before putting the Matco Spray Gun into operation.
SPECIFICATIONS
• MTDPGHV8 and MTDPGHV1 spray guns operate at low pressure of 29psi (2 bar) with the air cap pressure of 10psi
(0.7 bar). These spray guns produce high quality finishing results, while achieving a high transfer
efficiency above 65% and potential material savings up to 20~30%.
• Both MTDPGHV8 and MTDPGHV1 are suitable for use with all kinds of paint materials including waterborne.
10psi (0.7 bar)
for MTDPGHV8
and MTDPGHV1
Dual action trigger
• spray air only
• or air and paint
Use Regulator (not included)
for best performance and
increased efficiency.
MODEL:
MTDPGHV8
MTDPGHV1
Paint control
adjustment
MODEL
MTDPGHV8
Spray width
adjustment
MTDPGHV1
F0.3/0.5 NOZZLE ALSO AVAILABLE
• Maximum working pressure is 7 bar (100psi)
• Temperature range is between 5~40°C.
• Noise level is 78.8 dB(A) measured at 1m behind the tip of the gun
and 1.6m above the ground
• Atomizing air pressure is regulated at the spray gun inlet when the
trigger is pulled and the air flows.
Air in
ALL ABOVE RECORDS ARE FOR REFERENCE ONLY.
Page 2
GRAVITY FREED DETAIL
0.8 mm
HVLP SPRAY GUN
1.0 mm


(m
( mm) (psi) (  /min)
HVLP Low Pollution Series
0.8 75
29 76
1.0 95
AIR INLET: 1/4" PF/NPS(M)
Cup Capacity
 /min)
(mm) (kw)

95
0.13
0.75~1.5
0.25
110
FLUID INLET:1/4" PF/NPS(M)
AL/PL

AL