Broan NDK358 Serie Manual De Instrucciones

NDK358 SERIES
NON-DUCT FILTER KIT
For use with Broan AP Series or RP2 Series
range hoods.
15 /
13 "
16 (30" hood)
15 /
16 "
16 (36" hood)
CABINET FRONT
HOUSING
MOUNTING
SCREWS (4)
WOOD SHIMS
(recessed-bottom
CENTER
cabinets only)
LINE
1. Screw the 4 MOUNTING SCREWS (provided) into
the CABINET BOTTOM where shown. Recessed-
bottom cabinets require WOOD SHIMS to be
secured to the cabinet bottom before attaching the
mounting screws.
2. Remove VERTICAL DUCT KNOCKOUT from hood.
15 /
13 "
(30" hood)
16
15 /
16 "
16 (36" hood)
1½"
CABINET
BOTTOM
VERTICAL DUCT
KNOCKOUT
HOUSING
MOUNTING
SCREWS
9"
HEX
NUTS
3. Lift the hood up and over the 4 THREADED
STUDS. Secure hood to HOUSING with 4 HEX
NUTS (provided).
ALUMINUM
FILTER
ALUMINUM FILTER
FINGER RING
4. Remove ALUMINUM FILTERS from hood
(if previously installed).
5. Slide ALUMINUM FILTERS beneath TABS on NON
DUCT FILTERS. Make sure FINGER RING faces
outward. Install filters into hood with ALUMINUM
FILTERS facing outward.
Replacement Filters:
• Non-Duct Filter ...............................................88F
• Aluminum Filter (Qty. 2) ..................................97017455
• Aluminum Filter with Microban
THREADED
STUDS
ALUMINUM
FILTERS
NON DUCT
FILTER
NON DUCT
FILTER TABS
(Qty. 2)..........97017456
®