Tabla de contenido
Publicidad
7. Remember that bad maintenance leads to unsafe conditions and notably faster impoverishment of the
playground area.
8. Replacement parts can be ordered at the manufacturer with the OEM part numbers on the module drawing.
Drawings can be found in the user guide.
9. The impact area shall be provided with impact attenuating surface according to the specified falling height.
•
Up to 0,6m height of fall: no requirements regarding impact attenuation.
•
Turf, topsoil: suitable up to 1000mm height of fall.
•
Loose fill (sand, gravel, bark, woodchips): up to 3000mm height of fall. Layer thickness is height
of fall / 10 +100mm, with a minimum of 300mm.
•
Synthetic surfaces (Rubber tiles, artificial turf, wetpour, tigermulch etc.): height of fall and layer
thickness according to the information of the supplier.
10. This list is conform the CEN-standard "playground equipment and surfacing NEN-EN 1176-7".
Improving the
foundations
(for equipment without concrete in the standard
foundation)
If the impact area is loose fill (sand, gravel, bark,
woodchip, etc.), or if the soil itself does not add to
stability of the equipment (i.e. sand, pumice, peat soil)
pour 50l of concrete per post.
For instance:
Square: 0,6 x 0,6 x 0,16m
Round: ø0,35 x 0,5m
Round: ø0,50 x 0,2m
Publicidad
Tabla de contenido
