Sunblaster G139 Manual Del Usuario página 3

SETTING UP
GARDEN
Setting up your Growlight Garden
is a simple process. Open the box
and remove all the pieces. You will
find all the parts as listed on the
card, depending on which garden
you purchased.
1. Place the curved canopy down
on a flat surface and insert two
bolts through the holes on the top.
Make sure the head of the bolts
are on the outside of the canopy,
on the same side as the logo. Snap
the Strip Light fixture into the ballast
clips. This will require some force so
make sure to hold and put pressure
on the ballast. One edge first, then
the second.
2. Remove the Growlight tube by
rotating the tube 90° to unlock
it from the ballast and slide the
pins out of the fixture. Attach the
NanoTech reflector by aligning the
reflector with the grooves on the
ballast and snapping it firmly into
place. Start by applying pressure
along one side and working your
way down towards the other.
Replace the Growlight tube by
aligning the pins on either side and
sliding the tube back into place.
Rotate the Growlight tube 90° to
lock it securely into the ballast, you
will hear a "click".
Remove the blue film from the
reflector.
3. Plug the power cord into the
sockets at the end of the light
fixture.
4. Flip the canopy upside down and
slide a ballast clip onto each bolt
and secure them in place with the
nuts provided.
YOUR GROWLIGHT
5. Insert the
support bars into the holes on
either side of
6. Insert the nut into the height
adjuster clamps and slide them onto
each support bar. Set your height
adjuster clamps to your desired
height by using the thumb screws
provided. Do not overtighten.
7. Slide the Growlight Garden
canopy over each end of the
support bars,
plastic caps on top of the support
bars to plug the holes and to hold
everything securely in place.
8. Place the watering platform, one
for the large Growlight Garden, or
two small ones if you purchased
a Micro Growlight Garden. Place
the wicking mat provided with the
black side up. This will carry water
to your plants once you add water
to the reservoir.
Pins
Nanotech
Reflector
Ballast
two aluminum
the base
then place
Grow Light Tube
Slide Pins into
Socket
Rotate 90
Tube 'locks' into
place
Grow Light
Tube
tray.
the
o
until