Free Warning Label Replacement - Black and Decker Alligator NLP1800 Manual De Instrucciones

FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-544-6986 for a free
replacement.
LATIN AMERICA: This warranty does not apply to products sold in
Latin America. For products sold in Latin America, check country
specific warranty information contained in the packaging, call the
local company or see the website for warranty information.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
– Yellow Pages –
for Service &
See 'Tools-
Electric'
Sales
Troubleshooting Section
If your Chain Saw does not operate correctly check the following:
Problem Possible Cause
• Tool will not • Battery not
start. installed properly.
• Battery not
charged.
• Unit will not
• Battery not
charge.
inserted into
charger.
• Bar / chain
• Chain too tight.
overheated.
• Lubrication
needed.
• Chain is loose. • Chain tension set
incorrectly.
• Chain tension set
• Poor cut
incorrectly.
quality.
• Chain needs
replacement.
• Unit runs but • Chain installed
does not cut. backwards.
• Oil is not
• Sawdust / debris is
getting to accumulated under
chain.
sprocket cover.
14
Possible Solution
• Check battery installation.
• Check battery charging
requirements.
• Insert battery into charger
until green LED appears.
Charge up to 9 hours if
battery totally drained.
• Refer to "adjusting chain
tension" section.
• Refer to "chain oiling"
section.
• Refer to "adjusting chain
tension" section.
• Refer to "adjusting chain
tension" section.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain. Lubricate before
each cut.
Refer to "replacing the
chain" section.
• Refer to sections for
installing and removing
chain.
• Remove battery, remove
sprocket cover. Clean out
accumulated sawdust / debris.