Setting Parameters; General; Description Of The Functions On The Display; Reading The Display - MS Schippers 4509705 Modo De Empleo

1. Setting parameters

1.1 General:

3-0

1.2 Description of the functions on the display:

3-0 Display
3-1 Signal indication Out 1
3-2 Signal indication Out 2
3-3 Switch button
3-4 OK button
3-5 Switch button

1.3 Reading the display:

In the display above the temperature indication you can see two signal indications with a LED:
When the LED "Out 1" is lit, this means that the Climate box is in heating mode.
When the LED "Out 2" is lit, this means that the Climate box is in cooling mode.
If neither LED is lit, this means the box has reached the required temperature. The standard temperature is 17 degrees
Celsius. If there is no LED alight at a lower temperature (for example 12 degrees Celsius) then the parameters have been
changed.
If a LED is lit at too low a temperature (for example 12 degrees Celsius) then the probable cause is failure of the fan or
heating element. In this case please contact our Service Department
The product numbers of the spare parts are:
- art. nr. 8803517 digital display
- art. nr. 8809505 heating element

2. resetting the standard factory parameters

On delivery, your MS Climate Box has been set to the required parameters. In order to prevent changes by accident or
mistake, a password has been set into the system.
This User Manual is for those times when you want to change these parameters, or if you have made wrong changes and
you are not able to reset the required parameters.
If you want to reset the standard factory parameters into the operating system, follow the steps below till the paragraph
about the neutral zone on page 6 of this manual!!!
1 Switch the MS Climate Box off by unplugging the power plug from its power supply.
2 Hols in the "OK" button while reconnecting the power supply.
3 The display will show "DEF"
4 Follow the instructions on the following pages:
12
3-1
3-2
3-3
3-4
3-5