Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WIRE CONNECTION
LINE OUT:
RED (RIGHT) WHITE (LEFT)
ANTENNA WIRE: BLUE
FRONT AUX IN
CONNECTOR A
4.
MEMORY +12V
7.
+12V (TO IGNITION KEY)
8.
GROUND
Note: (connector A no. 7) must be connected by car ignition
key in order to avoid that car battery being drained when the
car will be not used for long period.
CONNECTOR B
1.
REAR RIGHT SPEAKER (+)
2.
REAR RIGHT SPEAKER (-)
3.
FRONT RIGHT SPEAKER (+)
4.
FRONT RIGHT SPEAKER (-)
5.
FRONT LEFT SPEAKER (+)
6.
FRONT LEFT SPEAKER (-)
7.
REAR LEFT SPEAKER (+)
8.
REAR LEFT SPEAKER (-)
Note: If your car does not have ISO connector, you can procure it from any car accessory shop
INSTALLATION
PRECAUTIONS
•
Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of
the driver.
•
Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot
air from the heater, or where it would be subject to dust, dirt or excessive vibration.
•
Use only the supplied mounting hardware for a safe and secure installation.
•
Be sure to remove the front panel before installing the unit.
NOTE: Inclination angle for car radio installation must not exceed 30˚ otherwise the front panel will not open.
1
1
release screw and
bracket
2
Note:
Keep the release key in a safe place as you may need it in future to remove the unit from the car.
TO SUPPORT THE UNIT
1. UNIT
2. RELEASE CASE
3. DASH BOARD
4. HEX NUT
5. LOCK WASHER
6. PLAIN WASHER
7. CAR BODY
8. REAR SUPPORT STRAP
9. TAPPING SCREW
10. M5 X 15 HEX BOLT
ANTENNA
CONNECTOR
2
3
LINE OUT
L (WHITE) R(RED)
3
TAP
182mm
53mm
Bend these
claws, if necessary
3
Dashboard
2
10
1
EN-2
B
A
ANTENNA WIRE (BLUE)
BLUETOOTH ANTENNA
CONNECT TO
EXTERNAL MICROPHONE
4
4
4
6
5
8
FUSE 10A
ISO CONNECTOR
1 3 5 7
2 4 6 8
7
4
8
182mm
53mm
7
4
5
6
9
Publicidad
Tabla de contenido
