Hanging The Fan; Electrical Connections; Blade Installation - Wind River Spas Frisco Manual De Instrucciones

3

Hanging the fan

WARNING: Please use all of the parts hardware and components provided by Wind River. The use of
other parts, hardware or components not supplied by Wind River with the fan will void the Wind River
Warranty.
REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
Step 1. Attach the mounting bracket to the outlet box with two screws and washers provided with the outlet
box. Make sure the mounting bracket is tight and secured. (Fig.4)
Stpe 2. Lift the fan into position by hanging the mounting plate portion of the fan motor assembly onto the
hook from the ceiling mounting bracket allowing it to hang freely. (Fig 5)

Electrical connections

REMEMBER to shut the power off at the circuit breaker or fuse box.
Follow the steps below to connect the fan to your house supply wires. Use the wire nuts supplied with your
fan. Secure the wire nuts by wrapping the connection with electrical tape.
Step 1. Connect the black (hot) wire from the ceiling to the black and the blue wires from the fan. Connect
the white (Neutral) wire from the ceiling to the white wire from the fan. (Fig 6)
Step 2. If your outlet has a ground wire (Green or Bare Copper) connect the fan ground wires (from hanger
ball and mounting bracket) to it; otherwise connect the fan ground wire wires from the hanger ball and
mounting bracket together. (Fig. 6)
Attaching the fan motor assembly to the mounting bracket
Step 1. Remove one of the four screws on the mounting bracket and loosen, but do not remove, the other
three screws.
Step 2. Remove the motor assembly from J hook.
Step 3. Lift and place the key holes on the mounting plate over the three screws previously loosened on the
mounting bracket and turn the mounting plate until it locks in place and no longer turns. (Fig. 7)
Step 4. Secure by tightening the three screws previously loosened and the screw previously removed.
(Fig. 7)
Finishing the fan installation
Step 1. Align the four large screwheads pre-locked on the fan housing to the key holes of the mounting
bracket. (Fig. 8)
Step 2. Turn the fan housing at the right side and twist the screwheads to the end of the slotted holes until
they lock in place and no longer turn.
WARNING: Installation without proper procedures as above mentioned might cause the fan fall off.

Blade installation

Step 1. Attach the fan blades to the blade brackers by using three blade screws and fiber washers. Tighten
screws and fiber washers securely.(Fig. 9)
Step 2. Remove the ten blade bracket screws from the bottom of the motor.
Step 3. Align the motor holes to the blade bracket and secure with the blade bracket screws. Tighten the
screws securely. (Fig. 10)