Worx Professional Sonicrafter WU675 Manual De Instrucciones página 11

OPeRATION
Warning: Do not touch the gear box after long working time,
because it could be hot.
1
MOuNTING THe TOOL (see Fig. B1,B2)
Caution: For all work or when changing application tools,
always wear protective gloves. Avoid danger of injury from the
sharp edges of the application tools. Application tools can become
very hot while working, presenting danger of burns!
Warning: To reduce the risk of injury, do not let the
universal end cut blades or any segment saw blades face
back toward the user's hand.
Unscrew the fastening piece (8).
Clean the tool holder, the application tool and bolt and the fastening
piece (8).
Place the application tool exactly onto the hex-shaped tool holder.
Note that the application tool has a flush fit.
Reposition the fastening piece (8) using the supplied Allen key.
2
AdAPTeR (22) (see Fig. B3)
Accessories of other brands(Fein
Sonicrafter brand tool using the adapter.
®
Note: Fein is a registered trademark of C. & E. Fein
®
Bosch ® is a registered trademark of Robert Bosch
1) Use the Allen Key (24) to unscrew the fastening piece (8) and
then remove it from the tool holder.
2) Clean the tool holder, the adapter the application tool and the
fastening piece.
3) Fit the adapter onto the tool holder, then place the application
tool onto the adapter. Make sure that the tool holder, the
All manuals and user guides at all-guides.com
, Bosch ) can be fitted onto the
® ®
GmbH.
®
® GmbH.
adaptor, and the application tool share a flush fit.
4) Reposition the fastening piece onto the application tool and
tighten with the Allen key.
Note: Make sure the adapter matches the application tool. The
adapter (I) is matched to the application tool of Fein
(II) is matched to the application tool of Bosch
3
MOuNTING / CHANGING THe sANdING sHeeT (see Fig. C)
Align the sanding sheet and press it onto the sanding pad by hand.
Firmly press the power tool with the sanding sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the sanding sheet, turn it
120° and place it on again.
4
OPeRATING THe ON/OFF sWITCH
To start the machine, push the On/Off switch (2) forward so that
the "I" is indicated on the switch.
To switch off the machine, push the On/Off switch (2) toward the
rear so that the "0" is indicated on the switch.
5
usING THe VARIABLe sPeed CONTROL
Select oscillation frequency (speed) while the motor is running.
The variable speed control (5) can be used to set the optimum
oscillating frequency according to the accessories used and the
respective application.
High oscillation frequency: Sanding, sawing, rasping and polishing
stone and metal.
Low oscillation frequency: Polishing varnishes.
9
. The adapter
®
.(See Fig. B3)
®