Cleaning The Dust Container - EURO-PRO V1935Q Guia De Inicio Rapido

OPERATING INSTRUCTIONS

Cleaning the Dust Container

For best performance, empty the dust container after each use.
1. Pull the dust container straight out from the side. (Fig. 6)
2. Empty dust container contents. (Fig. 7) If desired, rinse with water to clean the dust
container - but dry thoroughly before replacing on the sweeper.
3. Replace dust container on cordless sweeper.
4. Periodically remove the transparent brush cover on the front of the cordless
sweeper and remove any build up of lint, hair or fiber on the rotating brush. To
remove the cover - grip the cover from the bottom, pull out and downward until the
cover unlocks from the side slots and tabs located on the top of the sweeper. (Fig. 8)
CAUTION:
Do not accidentally turn unit "On" while cleaning.
Do not clean while unit is charging.
Fig. 6
Fig. 7
Fig. 8
5
OPERATING INSTRUCTIONS
Charging the Cordless Sweeper
1. Connect the charger plug to the charging jack
or hole on the back of the sweeper. Plug the
charging adapter into the wall outlet.
(120V., 60Hz.) Use only charger
KA12D075015023U. (Fig. 9)
2. This cordless sweeper is powered by Ni-Cd
batteries. Before first use, they must be
charged for a minimum of 20 hours.
IMPORTANT
: After initial charging, your new
cordless sweeper should not be left connected
to the charging adapter for a period in excess of
24 hours. A normal charge cycle is approximately 20 hours. The manufacturer
recommends that when charging the cordless sweeper, the unit be allowed to
charge for approximately 20 hours and then be disconnected from the charging
adapter. The charging adapter should be unplugged from the wall receptacle and
stored in a convenient place until next use.
3. When recharging the unit, the on/off switch must be in the "Off" position.
4. The charging light indicator on the top of the sweeper will illuminate to indicate that
the sweeper is charging.
5. To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
NOTE:
If you place the sweeper to recharge and the charging indicator light does
NOT illuminate, then press the on/off button once to turn the sweeper "Off". The
charging indicator light should now light up.
NOTE:
Peak performance may only be realized after the unit has been charged
and discharged two (2) or three (3) times.
IMPORTANT:
To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then
completely re-charged at least once a month.
CAUTION:
Use only with the battery pack supplied with the unit.
Do not attempt to remove the battery pack from the unit to
charge it.
Never attempt to throw the battery pack or unit into a fire or
incinerate it.
Do not attempt to remove or damage the battery casing.
Battery must be recycled or disposed of properly at the end of
its service life.
Fig. 9
6