Preparation Before Use - FAR C16IX CI Manual De Instrucciones

ENGLISH
ASSEMBLY
WARNING
1. Check that the voltage indicated on the base of the appliance matches the voltage
provided by your power grid before plugging in the appliance.
2. Don't use the appliance if its power cable, plug or any other of its parts is damaged.
3. This appliance is not designed to be used by persons (including children) with
reduced physical, mental or sensory abilities, or lacking experience and knowledge,
unless a person responsible for their safety has provided them with instructions
concerning the use of the appliance or supervises them during its use.
4. Never allow children to play with the appliance.
GB-6
5. Never leave the appliance unsupervised when it is in operation.
6. Never insert your fingers or any other object in the hopper when the appliance is in
operation. Only use the pusher for this purpose.
7. Do not touch the small cutting blades located on the filter base. They are very
sharp.
CAUTION
1. This appliance is designed exclusively for domestic use.
2. Prior to turning on the appliance, check that all of its parts are properly assembled
(Image B).
3. Only use the appliance when both flanges of the clamp are locked.
4. Only unlock the clamp after having switched off the appliance and waited until the
filter has completely stopped turning.
5. Do not operate the appliance for more than 40 s in a row when processing heavy
loads. Between uses, allow sufficient time for the appliance to cool down. None of
the recipes included in this operating manual represent a heavy load.
6. Do not remove the pulp bin when the appliance is in operation.
7. Always unplug the appliance from the mains socket after use.

PREPARATION BEFORE USE

1. Clean all removable parts (see the chapter "Cleaning").
2. Pull the power cable out of its storage housing in back of the appliance. Place the
juice collector in the appliance. Place the pulp bin by tilting it slightly forward.
First insert the upper part of the pulp bin, and then push in its lower part.
3. Do not empty the pulp bin while juice extraction is in progress. Switch off the
appliance and carefully remove the pulp bin.
Note: Re-assemble the empty pulp bin before continuing to extract juice.
1. Place the filter in the juice collector. Position the cover over the filter and lower it
into position.
2. Check that the filter and the juice collector are firmly fitted onto the drive axle
(click)
3. Fit the clamp on each side of the cover to lock it into position (clicks). Align the
groove of the pusher with the hopper's small internal stop and insert the pusher in
the hopper.
ENGLISH
GB-7