Installation Instruction; Electric Connection - iCES IWC-660 Manual De Instrucciones

Installation Instructions
V V V V .
Before using your wine refrigerator
Remove the exterior and interior packing
Check to be sure the following parts are included:
2 Slide out shelves.
1 Instruction manual.
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
Foe recedes installation away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold or hot ambient temperatures may also cause the appliances not to
perform properly.
Not designed for placement in adage or basement.
The appliance is for indoor use only.
aution:
C
Please keep the appliance away from substance, which can cause ignition.
Electrical Connection
VI VI VI VI.
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by an authorized Products service center.
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
2-pin plug which mates with 2-pin wall outlets to minimize the possibility of electrical shock. Do not
under any circumstances cut or remove the ground wine from the power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 220V-50HZ electrical outlet with 2-pin plug.
The cord should be secured behind the wine refrigerator and not let exposed or dangling to prevent
accidental injury.
Warning
2