Timer; Using The Oven; Before Using The Oven; Removing And Replacing Standard Oven Racks - Signature Kitchen Suite SKSSV3001S El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Timer

The oven timers don't affect oven operation or
cooking time. Use them as extra kitchen timers. Once
the time runs out, the oven chimes and "Timer 1 or 2
finished" appears in the display.
Setting the Timer
1
Touch either clock icon
display.
2
Scroll through the numbers in the popup until
the desired time appears in the display or touch
the number pad icon(
directly and touch OK.
3
The time remaining appears next to the clock
icon in the display.
Adjusting or Cancelling the Timer
1
Touch the remaining time next to the clock icon
in the display.
2
To cancel the timer, touch Reset (
popup. Then touch OK.
3
To adjust the time, scroll the numbers in the
popup until the desired time appears. Then
touch OK.
4
The remaining time in the display is adjusted.
at the bottom of the
) to enter the numbers
) in the

Using the Oven

Before Using the Oven

NOTE
• The temperature registered by an oven
thermometer may differ from the actual set
oven temperature.
• It is normal for the convection fan to run while
preheating during a regular bake cycle.
• The convection fan motor may run periodically
during a regular bake cycle.
Removing and Replacing Standard
Oven Racks
The racks have a turned-up back edge that prevents
them from being pulled completely out of the oven
cavity.
CAUTION
• Replace oven racks before turning the oven on
to prevent burns.
• DO NOT cover the racks with aluminum foil,
or any other material, or place anything on the
bottom of the oven. Doing so will result in poor
baking and may damage the oven bottom.
• Only arrange oven racks when the oven is cool.
Removing the Racks
1
While wearing oven mitts, grasp the oven rack.
2
Pull the rack straight out until it stops.
3
Lift up the front of the rack.
4
Pull out the rack.
Replacing the Racks:
1
While wearing oven mitts, place the end of the
rack on the support.
2
Tilt the front end of the rack up.
3
Push the rack in.
4
Check that the rack is properly in place.
OPERATION
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido