Dynex DX-2P2C Guia Del Usuario página 5

Setting up the USB card
Installing the software drivers
To install drivers for Windows XP SP1 (or later) and
Windows 2000:
1 Make sure that you have installed the card into your
2 When Windows starts, insert the DX-2P2C CD into your CD
3 Run the file setup.exe on the CD. The installation wizard
4 Click Next.
5 Select Install USB 2.0 Driver, then click Next.
6 Click Yes to continue. Your computer restarts when the
Note: Driver installation steps may vary from the steps listed
below if you use an upgraded operating system. If the screen
messages differ from the instructions below, follow the
on-screen prompts.
computer, then turn on your computer.
or DVD drive.
opens.
installation is complete.
Note: Microsoft EHCI drivers for Windows XP are not included
in this package. If the following window appears, please
update your system to Windows XP SP1 or SP2, then run the
setup program again.
5