Customer Service; Safety Precautions - One for All SV-1100 Guía Del Usario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
The RECEIVER can be interfered with an external RF signal. The LED (A/B) of
the RECEIVER will blink even without pressing a key on the remote control.
If this is the case, please try the below:
1.
Try to move the RECEIVER.
2.
Reduce the antenna length.
3.
Set the switch to position "C".
Recharging the (2/3 AAA size) Battery
Your RECEIVER is also the recharging-station for the included (2/3 AAA size) battery.
If your remote control is functioning at a shorter distance than normally (when the LED
(A/B) of the RECEIVER does not blink when a key on the remote control is being pressed)
then the battery needs to be recharged.
1.
Remove the (2/3 AAA size) battery from your remote control.
2.
Place the (2/3 AAA size) battery in the compartment that you can find on the bottom
of the RECEIVER. The LED (BAT) will light up.
3.
The LED will switch off as soon as the (2/3 AAA size) battery is fully charged.
NOTE: The RF operating range may vary depending on the overall battery charge (e.g.
you may have to replace the alkaline batteries if the operating range decreases).
Caution: Use only with supplied rechargeable battery. Risk of explosion if battery is
installed by an incorrect type.
Before contacting us, make sure to have the following information available;
1. The modelnr. of your ONE FOR ALL: SV 1100
2. The date of purchase (..................../..................../....................).
3. Clear description of the problem.
In the UK:
0906-9695654 ( £ 1 per minute )
-
This product should only be used with the AC power adapters included or a type that complies with safety standard
EN60065 and that has the following specification: 12 Volt DC / 150 ~ 300mA.
-
This product should not be exposed to high temperatures.
-
This product should not be used in damp places or close to water.
-
The AC power adapters should only be connected to a power supply of 220-240 VAC / 50Hz.
-
This product should not be covered.
-
Inadequately protected or sensitive electronic equipment may be affected by the use of this product.
This interference can lead to damage to either equipment. Before you start, please check whether or not
this product can affect surrounding equipment.
5
Interference

Customer Service

Safety precautions

WWW.ONEFORALL.COM

Publicidad

Tabla de contenido
loading

Tabla de contenido