Avtech AVM359A Guía Rápida página 4

QUICK GUIDE
Please read instructions thoroughly before operation and retain it
for future reference. Online manual download:
www.surveillance-download.com/user/m359a.swf
 INSTALLATION
Step1: Locate where you want to install this camera, and
fasten the camera to the ceiling or wall.
Note: It's recommended to slightly loosen the screw on
the bracket as indicated below to move the camera
down a little bit. It's easier for bracket installation
to the ceiling or wall.
Slightly
loosen
 PACKAGE CONTENT
Before starting to set up your camera, please make sure
items below in your box:
Camera Sun Shield
For selected models only:
Wall Wrench
Screws Desiccant
Plugs
*
Step2: Adjust the viewing angle of the camera, as indicated below.
Horizontal
Slightly
loosen
Step3: Power on the camera, and follow the steps in the next section "ADJUST FOCAL LENGTH & FOCUS" if necessary.
Step4: Slide the sun shield to the camera, and fasten it with the supplied screw.
 CABLE OVERVIEW
Below is an overview of various cables that can be used
with the camera. Besides, it is followed by a table, which
offers simple descriptions of cable connection.
Quick guide
Cable
Power cable
RJ45 network cable*
GND
Alarm-in
Alarm-out
RESET
* For PoE (IEEE802.3af) installation, make sure your network cable has
the maximum cable resistance of 20Ω, such as CAT.5e or CAT.6 cables, to
conform to the standard of IEEE802.3af.
Vertical Rotate
Slightly
loosen
596Z
RJ45 network cable
Alarm-in
GND
RESET
GND
Alarm-out
Power cable
Description
DC12V power supply.
Connect it to a RJ45 cable.
Ground wire
Reserved for external alarm device
connection
Reserved for external alarm device
connection
Remove the insulating coating of wire, and
twist it with a ground wire together to reset
default camera
Slightly
loosen
m552c_553_quick_V1.0