First Time Use - iStorage diskashur PRO2 Guia De Inicio Rapido

First Time Use

Your diskAshur PRO undergoes a rapid self-test to verify all security components are working properly each time
2
you plug into a powered USB port. The LEDs will go through 3 test stages, blinking in sequence RED,
BLUE, followed by two GREEN
force the diskAshur PRO to securely reset itself and automatically resume the self-test without affecting the security
2
characteristics or any data stored on the drive.
Please follow the instructions in the table below to unlock the diskAshur PRO
Admin PIN.
Instructions - first time use
1. Connect the diskAshur PRO
Standby State
2. In Standby State (solid RED
hold down 'UNLOCK + 1' buttons
3. Enter the Admin PIN (default - 11223344)
and press 'UNLOCK' button
4. Press the 'UNLOCK' button once again to
unlock diskAshur PRO and access drive contents
2
Note: Once the diskAshur PRO2 has been successfully unlocked, the
and in a solid state and will only blink when data is being transferred. It can be locked down
immediately by pressing the 'LOCK' button once or by
'Safely Remove Hardware/Eject' icon within your operating system.
4
(Standby State) on a successful test. Any test failure will
blinks and then to RED
LED
to a USB port -
2
LED), press and
for the first time with the default
2
LED State
RED LED will be solid awaiting PIN entry
Solid RED LED will change to blinking
GREEN and BLUE LEDs
GREEN and BLUE LEDs blink rapidly
together for a few seconds then to a
solid GREEN and finally a solid
indicating the diskAshur PRO
Mode"
Solid BLUE LED will change to a blinking
GREEN, and finally a solid
indicating the diskAshur PRO
GREEN LED will remain on
(strongly recommended) clicking the
GREEN and
BLUE LED
is in "Admin
2
GREEN LED
is unlocked
2
4