Filter Replacement; Specifications; Troubleshooting - Oregon Scientific i.fresh NCCO Manual Del Usuario

• Clean the nano filter with a vacuum cleaner
or a brush.
• Remove the nano filter before cleaning with a
vacuum cleaner.

FILTER REPLACEMENT

Nano Filter
In case of normal household use in a non-smoking
environment and in case of proper maintenance
(see chapter 'Cleaning and maintenance'), the
nano filter lasts up to 3 years.
NOTE
Note: You may need to replace the nano filter
sooner in case of using in a more extreme
environment (smoking
renovated room, non-domestic use etc) and
insufficient maintenance.
Removing the filter
1. Turn the air outlet cover counterclockwise and
lift it up gently.
Slide the nano filter security lock to unlock
2.
position.
3. Pull the nano filter out gently.
Inserting the filter
1.
Turn the air outlet cover counterclockwise and
lift it up gently.
2. Push the nano filter into the filter cartridge
lightly with the arrow on the top of the filter
facing the unit.
3.
Slide the nano filter security lock to lock
position. You should hear a "click" sound from
the lock if the cartridge is properly placed.
4.
Reattach the nano filter cover. Turn the cover
clockwise until you hear a "click" sound.
Pre-Filter
In case of using in a non-smoking normal
household and in case of proper maintenance
(see chapter 'Cleaning and maintenance').
Removing the filters
1. Pull the air inlet cover out with your thumb and
middle finger.
2. Take the cartridge out from the unit and
remove the pre-filter away from the holder.
Inserting the filters
1.
Pull the air inlet cover out with your thumb and
middle finger.
2.
Put the pre-filter into the product unit properly.
3.
Press on the both sides of inlet cover lightly
with your thumb and middle finger. Push it to
the unit with the markings of main unit and the
inlet cover aligned as illustrated below.
environment, just

SPECIFICATIONS

TYPE
MAIN UNIT
L x W x H
Weight
Power

TROUBLESHOOTING

This chapter summarizes the most common
problems you could encounter when using the
unit. If you are unable to solve the problem with
the information below, contact the Consumer Care
Centre in your country.
Problem
The unit doesn't
work.
The clean air doesn't
come out smoothly
from the air outlet
The odors are not
removed properly.
The unit produces
an unusual noise
(e.g. a hissing,
sizzling or
crackling) during
operation.
4
DESCRIPTION
150mm(L)x150mm(W)x325mm(H)
(5.9in x 5.9in x 12.8in)
1800g (62.79oz)
12V DC power adaptor:
INPUT 110-240V 50/60Hz
Solution
• There may be a connection
problem. Check if the plug
is inserted to the wall socket
properly.
The filters are not inserted
•
yet or not inserted properly.
Insert the filters and reattach
the inlet and outlet covers.
Perhaps you have not
•
removed the plastic wrapper
from the new filter. Remove
the plastic wrapper and
switch on the unit again.
• Perhaps the ambient air
quality of the room is very
poor. In that case, open
the windows to improve the
air circulation.
The nano filter may be too
•
dirty or may have reached
the end of its life. You
should clean the nano filter
(see chapter "Cleaning and
Maintenance") or replace
it (see chapter "Filter
Replacement").
• Perhaps the room size
is bigger than the unit is
intended for. Use the unit
in a smaller room. The
recommended room size is
5m² up to 20m².
The air inlet or outlet may be
•
blocked by external objects.
Remove the object that
blocks the air inlet or outlet.