Audio Settings - PS3 CP-KIT Manual Del Usuario

SETTING UP YOUR PS3™ SYSTEM
CHAT SETTINGS
So that you can hear other players you must set-up
your PS3™ system as follows:
1. Turn on your PS3™ system; go to "
"Accessory Settings" > "Audio Device Settings".
2. Select "Input Device" and select "4Gamers™
Official USB Headset" from the options.
3. Select "Output Device" and select "4Gamers™
Official USB Headset" from the options.
4. Select "Microphone Level" and adjust so that the
on-screen audio indicator bar just reaches the red
area when you speak loudly. Microphone level 3 is
recommended. If you select a level that is too high
you may encounter feedback from noise around
you.
5. Select "OK" to save.
Audio Device Settings
Microphone Level 3
Input Device
Output Device
X Enter

AUDIO SETTINGS

So that you can hear the game audio through the
headset, you must make sure that your PS3™ system
is set-up as follows:
" " > "Sound Settings" > "Audio Multi-Output">
"ON"
IN-LINE CONTROL UNIT/AMPLIFIER
GAME
">
4Gamers Official USB Headset
4Gamers Official USB Headset
OK
O Back
CHAT
MIC MUTE
FREQUENTLY ASKED QUESTIONS
Q: No one can hear me speaking
A: Try the following:
• Ensure you have the Mic Mute switch set to its
OFF position.
• Move the Microphone closer to your mouth.
• Try setting the Microphone level on your system to
a higher level.
• Ensure you have selected "4Gamers™ Official
USB Headset" in the PS3™ system's Audio Device
Settings.
Q: I can't hear any game or chat sound through the
headset
A: Try the following:
• Ensure that you have turned the dual in-line
volume controls up.
• Check the audio settings on your PS3™ system.
STEREO GAMING HEADSET
Technical Specification
Driver size:
Frequency response:
Impedance:
Sensitivity:
Maximum input power:
OFC cable:
Cable length:
HIGH SPEED HDMI CABLE WITH ETHERNET
®
For set-up, see point 3 of Headset Connection,
outlined earlier in this manual.
FEATURES:
• Produces High Definition picture and sound.
• High quality triple shielded 2 metre cable.
• Supports 3D games and movies*
• Provides 4K resolution.
• Nickel plated cable heads.
• Gold plated connectors.
*AV equipment must be 3D compatible
DUAL CHARGE 'n' STAND
The Dual Charge 'n' Stand works as a desk
tidy/storage unit for your DUALSHOCK
Controllers, whilst the twin USB cables charge your
DUALSHOCK 3 Wireless Controllers straight from
®
your PS3™ system.
Connection:
1. Connect the two standard USB connectors from
the charging cable into the USB connectors on the
front of your PS3™ system.
2. Connect the mini USB connectors into the USB
connectors on your DUALSHOCK
Controllers.
40mm Driver
20-20,000Hz
32 ohms
108 dB
0.1W
Yes
4 metres
3 Wireless
®
3 Wireless
®