Maintenance, Cleaning, And Storage - TIE DOWN 13864 Instrucciones De Instalación

Maintenance, Cleaning, and Storage

If anchor fails inspection in any way, immediately remove it from service, and contact TIE
DOWN to inquire about its return or repair. Cleaning after use is important for maintaining the
safety and longevity of this anchor. Remove all dirt, corrosives, and contaminants from the
anchor before and after each use. NEVER clean anchors with corrosive substances. When not
in use, store equipment where it will not be affected by heat, light, excessive moisture,
chemicals, or other degrading elements.
Inspection
Prior to EACH use, inspect all anchors for deficiencies, including, but not limited to, corrosion,
deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive
heating, alteration, and missing or illegible labels. IMMEDIATELY remove any anchor from
service if defects or damage are found, or if exposed to forces of fall arrest.
Ensure that applicable work area is free of all damage, including, but not limited to, debris,
rot, rust, decay, cracking, and hazardous materials. Ensure that selected work area will
support the application-specific minimum loads set forth in this instruction manual. Work
area MUST be stable. At least every 6 months, a competent person other than the user must
inspect each anchor. The Competent Person must sign their initials in the box corresponding
to the month and year the inspection took place.
INSPECTION GRID
INSPECT BEFORE EACH USE. A competent person must complete a formal inspection every 6
months and document below with initials. The life of this roofing device is unlimited as long
as a competent person inspects and passes equipment as in good order every 6 months.
Date of First Use: _________________
Year
Month
Date
Initials
If this equipment fails inspection or is found to have deficiencies, remove from service.
Deficiencies include, but are not limited to deformation, corrosion, burrs, sharp edges,
cracking, rust, pits, excessive heating, paint buildup, alteration, damaged parts and
missing or unreadable labels.
Roofing Products Division
605 Stonehill Drive SW
Atlanta, Georgia 30336
800-241-1806 • 404-344-0000
www.tiedown.com
ISO 9001:2015 Certification
Intellectual property of TIE DOWN Inc.
©2018 TIE DOWN, Inc.
Instruction #08307 (E1602 Rev. 8/5/19)
Made in China