Telcoma Automations PASSO Instrucciones Para La Instalación página 51

GB
PROGRAMMING – INTRODUCTION OF THE USER CODE
press and hold the key for approx. 2 seconds until the keypad be- #
•
eps once.
introduce the MASTER code followed by , the LED
•
enter 01# to memorise codes for channel 1 of the receiver or
•
morise codes for channel 2 of the receiver, the LED
enter the code to be introduced followed by . The buzzer confirms
•
with a beep.
Proceed as above for any additional codes.
•
To exit the programming, press and hold the
•
emits a long beep followed by a double beep.
The keypad exits automatically from programming after a few seconds
of inactivity.
NOTE: - Each user code can only control one output relay.
- The user codes can be made up from 1 to 8 numbers.
- Codes of different lengths can be memorised on the same
system.
- A code cannot start with 0.
- The confirmation time of the codes introduced may increase
as the number of user codes memorised increases.
Example 1
I want to introduce the user code 12390 that will activate relay 1 of the
receiver
# 2233# 01#
2 sec. MASTER code command
Example 2
I want to introduce the user codes 456 and 789 that will activate relay 2
of the receiver
# 2233# 02#
2 sec. MASTER command new
code
# ☼ emains on.
02#
starts to flash.
☼
#
# key until the keypad
12390# #
new USER 2 sec. End of
programming
456# 789# #
new 2 sec.
USER (1) USER (2) End
to me-
51